Rosso Fiorentino Certaldo Series 2 Speakers

Rosso Fiorentino Certaldo Series 2 Speakers

CERTALDO SERIES 2 INHERITS THE HYBRID REAR/DOWN FIRING LOADING SYSTEM OF THE PREVIOUS VERSION AND FURTHER DEVELOPS IT.
Enclosure volume was increased around 10% and in order to obtain a greater low-end octave authority and reduced distortion the 5.25” mid-woofers were re-engineered focusing on the motor venting system and suspension material. 
An additional improvement was also provided by the underneath aluminium port with its redesigned and enlarged gradual flaring which contributed to the overall over-damped yet powerful bass performance.

Having demonstrated an excellent overall performance we decided to reconfirm the 1” neodymium wide surround silk dome tweeter used in the previous Certaldo.

Thanks to the implementation of an all-new crossover, this unit has found a second youth integrating in an even more linear way with the midwoofers. Like its sibling Pienza, the Certaldo features a highly sophisticated enclosure, where a blend of mechanically different materials helps to render the cabinet incredibly still and inert allowing the wonderfully accurate and detailed drivers to operate with utmost clarity and dynamics.

Certaldo series2 implements a totally re-engineered crossover circuit which provides a more extended low frequency emission, a higher efficiency and a practically ‘resistive’ impedance which makes it possible to pair this model with a wide range of electronics. 

The use of top quality components like the custom Rosso capacitors made by ClarityCap, thick film resistors and our new made in Italy inductors adds that extra touch of refinement and dynamics to the full sound of this speaker.

Type
2.5 -way rear/down firing ported floorstanding system

Sensitivity
88 dBspl (2.83V, 1m)

Nominal impedance
8Ω (minimum 5Ω)

Drive units
1 x ø 25mm (1 in) silk dome neodymium tweeter
1 x ø 130mm (5.25 in) glass fibre composite cone mid-range
2 x ø 130mm (5.25 in) glass fibre composite cone mid-woofer

Frequency response (±3dB)
40 Hz – 30 kHz (typical in-room bass resp. -6dB @35Hz)

Crossover frequencies
200 Hz – 2.5 kHz

Recommended amplifier power
50W – 150W into 8Ω with unclipped sound signal

Cabinet
solid HDF fiberboard, aluminium front and side panels, internal damping pads

Dimensions
Height: 1075mm (42.3 in) incl. plinth and spikes
Width: 194mm (7.6 in) | 237mm (9.3in) including plinth
Depth: 262mm (10.3in) | 303mm (11.9in) including plinth

Net weight
28 Kg (61.7 lb) each

Cabinet finish
exclusive RF silky matt black coating
black carbon fibre pattern leather (front panel and side stripes)

Side panels
black high gloss lacquer
real walnut veneer
other finishes on request