Pro-Ject VTA IT Tonearm Spacer 1.5mm

(3 Reviews)

£11.50

£9.58 Exc. VAT |

Description
Customer Reviews (3)

Project VTA IT Tonearm Spacer 1.5mm

With the Pro-Ject VTA it, the vertical tracking angle of the tonearm can be adjusted. You can then use upgrade platters, mats and cartridges. VTA it is compatible with Debut I-III, Debut Carbon, Debut Carbon EVO, Essential I-III (only in the standard configurations). A Philips # 1 screwdriver & 5.5 mm nut driver wrench are required for installation.

The installation of “VTA it“ should be done by an experienced technician. Unauthorized installations void the warranty.

Features

Adjust the vertical tracking angle setting
Use thicker upgrade mats like Cork it
Compatible with: Debut I-III, Debut Carbon, Debut Carbon EVO, Essential I-III (only standard configurations)

Average Rating (3 Reviews):

Write a Review and share your opinions!

Rating:

VTA spacer

22 June 2022 | Warren

Fast dispatch and arrived promptly.
Spacer slides under the tone arm mount, loosen fixings, slide in spacer, tighten fixings. As per the instructions.
Used to correct stylus "rake angle" for an ortofon OM cartridge stylus (OM. 10). Which should be 20 degrees on the stylus cantilever.
Ortofon have a video explaining this very well.
I used a cheap usb microscope with its own measurement software to check the cantilever angle..
Used on a debut carbon.... The full alignment gave Great results.
Very happy... Thank you.

Was this helpful to you? Yes / No

1 of 1 people found this review helpful.

Rating:

Good

16 March 2022 | Alexander

Haven't used yet.

Was this helpful to you? Yes / No

This review has not been appraised.

Rating:

Did what I needed

05 August 2021 | Keith

I put a slipmat on to my Project turntable which was 1.5mm thick so needed this spacer